Here I have gotten everything I think I need to glue this sucker on. Glue, wet and dry paper towels, Q-tips, clamps and radius block with steel bar.
Glue is applied to both surfaces.
After inserting the neck I placed the 12" radius block on top of the fret board. I then placed the steel plate on top of that. I have the body on the 3/4" template board to protect the back. Then I tighten it down with 2 C clamps. After tightening I used the wet and dry paper towels, Q-tips to wipe off all excess glue.
Will let this set over night. Then I will take the clamps off.
No comments:
Post a Comment